|JANUARY||CUT AND ROUT STRIPS|
|FEBRUARY||Build Steam System and ADD STRIP PLANKS TO FRAMES|
|MARCH||ADD STRIP PLANKS TO FRAMES|
|APRIL||FAIR AND FIBERGLASS OUTER AND INNER HULL|
|MAY||CONSTRUCT INTERIOR SEATING AND MOTOR WELL|
|JUNE||INSTALL MOTOR AND LAUNCH|
I think it is doable, but I have been experiencing a little trouble ripping the twenty foot 5/4 red cedar planks into 1/4" inch strips. The board seems to drift from the table saw fence after about 15 feet or so. And if I clamp feather boards too tight, the board binds the blade and the saw blows a fuse.
A little perplexing, but nothing a MOAM can't solve.